I'm trying to align the turret on my 4NE-600. It is rotated up about 0.100" on the centerline of the ID tools (it took a crash). I'm having trouble figuring out which bolts might constitute an adjustment. I've loosened the six socket head bolts labeled "A" in the attached picture and pulled the two pins labeled "a" which definitely separated the toolholder portion of the turret from the fixed part, but there don't seem to be any slots to allow for the rotation. The "a" pins are cylindrical, not tapered.
I also removed the socket head caps labeled "B" and unscrewed the bolts underneath them. This seems to be where my turret has taken some force (two of the bolts were sheared), but again, I don't see any room for adjustment. If I remove the socket caps at "b", I can see that there are pins way down deep, but no way to remove them. It seems like these may be the pins that index into the backside of the turret?
Any help, or instructions on this procedure would be much appreciated.
-joel
Turret_bolts_front.jpg
I also removed the socket head caps labeled "B" and unscrewed the bolts underneath them. This seems to be where my turret has taken some force (two of the bolts were sheared), but again, I don't see any room for adjustment. If I remove the socket caps at "b", I can see that there are pins way down deep, but no way to remove them. It seems like these may be the pins that index into the backside of the turret?
Any help, or instructions on this procedure would be much appreciated.
-joel
Turret_bolts_front.jpg