Hi everybody, i am new to this forum...so please have patience with me.
I have a LeBlond Makino Baron 25 CNC lathe for which i am generating the third phase.
The machine was running very good and the following day when i power it up, i was sending HOME like i always do. The X axis homed perfect and the Z went half way and then the control and monitor went off.
I found a 2.0 Amp fuse next to the power supply was blown , i replace it and the machine came back up....BUT i can NOT get it out of E-STOP.
I looked at the wiring diagrams and i bypass the e-stop and the machine runs good....But i don't want to run it like that, it was just a test i was doing.
It is a FANUC 10T controller, i think it may be a bad relay or fuse that i am not seeing....
This machine is my only CNC and as you'll understand i am hurting bad.
Please try to help me as soon as possible.
Thank you and GOD bless you.
I have a LeBlond Makino Baron 25 CNC lathe for which i am generating the third phase.
The machine was running very good and the following day when i power it up, i was sending HOME like i always do. The X axis homed perfect and the Z went half way and then the control and monitor went off.
I found a 2.0 Amp fuse next to the power supply was blown , i replace it and the machine came back up....BUT i can NOT get it out of E-STOP.
I looked at the wiring diagrams and i bypass the e-stop and the machine runs good....But i don't want to run it like that, it was just a test i was doing.
It is a FANUC 10T controller, i think it may be a bad relay or fuse that i am not seeing....
This machine is my only CNC and as you'll understand i am hurting bad.
Please try to help me as soon as possible.
Thank you and GOD bless you.